Concrete Batching Plant
Mobile Concrete Batching Plant
Concrete Truck Mixer
Concrete Pump
Wheel Loaders
Block Making Machine
Asphalt Mixing Plant
Haomei News

Haomei analysis on concrete pump using some common questions

Jul 01, 2016

1. individual position, arm cannot be opened or cannot move possible causes:

* Hydraulic system pressure is not enough

* Other abnormal excess load on the arm

* Solenoid valve blocked or solenoid valves to burn out

Solution:

* If the maximum pressure of the valve value that indicates the value did not reach the arm work, should check whether the maximum pressure valve is not adjusted. If this does not rule out failure, indicates a damaged hydraulic pump, hydraulic pump should be replaced; the extra load is no longer acting on the arm.

* If in accordance with the preceding articles after inspection, the arm still does not work properly, you must check the instructions of a single control arm valve is working properly.

Haomei analysis on concrete pump using some common questions

2. arm-stretching or lifting the trembling too much may cause:

* Connection clearance

* The connection between pin and mount

* The thrust bearing between fixed and rotating parts

* The thrust bearing bolt release

Solution: replace the damaged part, lubrication frequency and ensure movement, replace thrust bearing, in accordance with the regulations tighten, tighten or replace the bolts.

 concrete pump using some common questions

3. after rotating arm stop too slow possible cause:

* Valve block occurred because of dirt blocked

* Pump static level

* Brake disc wear

* Brake spring deformation

Solution: clean or replace the valve block, lifting a leg, keep the pump level, replace the brake disc, brake replacement springs.

4. boom under load cannot be locked: the possible causes

* Lock valve block is not adjusting well, valve block is dirty or damaged

* Hydraulic cylinder leakage

* Adjustment or cleaning, replacement of the valve block, the replacement of seals, check that the tubing is damaged.

5. pin cannot be lubricated, possible causes:

* Oil nozzle blocked or damaged

* Lubrication pipes due to dirt and block

Solution: change the oil mouth, remove the PIN, check for cause of pipe blocking and wear and clearance. Note: this may lead pin killed, pins with the jib rotation, PIN card is destroyed. Here are two ways to remove the PIN:

* Add grease injection inlet and connection to the PIN, and then remove the

* Add grease to the PIN, I still cannot remove, use heat removal, it must replace the pins and bushings.

Your name :
Your tel :
* Your mail :
Your company :
Your country :
* Inquiry :

Pre:上一篇:Haomei trailer concrete pump container shipments exported abroad

Next:下一篇:HAOMEI concrete pump smooth running low risk