Concrete batching plant mixing system common breakdown and solution

First of all, must ensure that the power supply should be in the 380~400V range, and three-phase power balance. If the voltage is too high it may cause electrical burn, voltage is too low may cause the host cannot start or mirror, car,

His agency action or action is not in place, operating for a long time can cause damage to the concrete batch plant equipment.

Concrete batching plant mixing system:

Is cement, aggregate, water and additives in a certain proportion, mixed system of commercial concrete mixing some time. Includes mixing some additional.

Common symptoms are:

1: unloading door runs not smooth

2, mixing machine bored machine tripping

3, mixer noise, caused by mixing console does not run correctly, directly affect the efficiency of mixing machine.

Analysis:

1, discharge door jam is proximity switch is broken unit, hydraulic pressure is too small or the discharge door stuck

2, mixing machine bored machine tripped because the drive belt is too loose, stirring knife gap is too large, or misuse

3, mixer noise motor noise or mixing knife, roller noise damage.

Treatment methods:

1, replace the same type of proximity switches. Hydraulic unit: lack of hydraulic oil in hydraulic station, add hydraulic oil and adjust the pressure; inspect the discharge around the door for any buildup should be cleared up.

2, adjust the drive belt tension and adjust the mixing knife gap, replace the mixing knife; emergency programmes.

3, check whether the protective cover loose in a timely manner, bearing no problem check for lubricating oil up protective ring A/B with and without friction, such as promptly contact manufacturer.